HP 54501A - Page 15

Table
1-2 . HP 54501A Operating Characteristics
HP 54501A GENERAL INFORMATION
SETUP AIDS
(continued)

measurements, may be remotely programmed via
HP-IB (IEEE 488) .

HP-113 programming complies
Save/Recall :
Four front-panel setups (1-4) may be

with IEEE 488 .2-1988 "Standard Codes, Formats,
saved in non-volatile memory .

Protocols, and Common Commands"
.
Recall Clear . Resets
the HP 54501A to Its factory

Data
Acquisition and Transfer Rate : A 500-point
default settings .

data record can be acquired and transferred to a
computer at a rate of approximately 10 times per
Recall 0 :If Autoscale, ECL, or TTL
preset, or

second, as tested with an HP 9000, Series 200
RECALL SETUP
are Inadvertently selected,

Controller .
The acquired data was type normal,
RECALL 0
restores the memory to Its last state

completion criteria 100% with the oscilloscope at a
prior to selection
.

time/div setting of 5 A s/dIv .
Show :
Displays Instrument status, Including

Data Transfer Rates : Approximately 120 Kbytes/s .
volts/div,
offset, and trigger condition .
Probe Compensation Output : An
approximately
HARDCOPY : The CRT display,
Including menus

1 .5 MHz
signal Is provided for probe compensa-
and measurement results,
can be transferred

tion .

A
probe-to-BNC adapter is used to connect
directly to an HP-16
graphics printer, including the

the probe to the rear panel Probe Compensation
HP 2225A
ThInkJet® or compatible printers .

BNC output . During calibration, this
output is used
to provide other calibration
signals .
HP-IB PROGRAMMABILTITY
DC Calibrator
Output : This output is used for ver
Full Programmability :
The HP 54501A provides

tical
calibration of the HP 54501A .
full programmabilty
. Instrument settings and
operating
modes, including automatic