HP 6125XLG - Configuring IS-IS Route Redistribution; Configuring IS-IS Route Filtering

121
Configuring IS-IS route redistribution
Perform this task to redistribute routes from other routing protocols into IS-IS. You can specify a cost for
redistributed routes and specify the maximum number of redistributed routes.
To configure IS-IS route redistribution from other routing protocols:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Redistribute routes from
other routing protocols
or other IS-IS processes.
import-route protocol [ process-id |
all-processes | allow-ibgp ] [ cost cost
| cost-type { external | internal } |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name | tag
tag ] *
By default, no route is redistributed.
By default, if no level is specified, this
command redistributes routes into the
Level-2 routing table.
This command redistributes only
active routes. To display active
routes, use the display ip
routing-table protocol command.
4. (Optional.) Configure
the maximum number of
redistributed Level
1/Level 2 IPv4 routes.
import-route limit number
By default, the maximum number of
redistributed Level 1/Level 2 IPv4
routes is not configured.
Configuring IS-IS route filtering
You can use an ACL, IP prefix list, or routing policy to filter routes calculated using received LSPs and
routes redistributed from other routing protocols.
Filtering routes calculated from received LSPs
IS-IS saves LSPs received from neighbors in the LSDB, uses the SPF algorithm to calculate the shortest path
tree with itself as the root, and installs the routes to the IS-IS routing table.
Perform this task to filter calculated routes. Only routes that are not filtered can be added to the IS-IS
routing table.
To filter routes calculated using received LSPs:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Filter routes calculated
using received LSPs.
filter-policy { acl-number | prefix-list
prefix-list-name | route-policy
route-policy-name } import
By default, IS-IS accepts all
routes calculated using
received LSPs.