320
2.2.2.2 0 2-Way/DROther 00:00:36 Vlan200 0
3.3.3.3 2 Full/Backup 00:00:35 Vlan200 0
4.4.4.4 1 Full/DR 00:00:33 Vlan200 0
# Display neighbor information on Switch D. Switch D is still the DR.
[SwitchD] display ospfv3 peer
OSPFv3 Process 1 with Router ID 4.4.4.4
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID Pri State Dead-Time Interface Inst ID
1.1.1.1 100 Full/DROther 00:00:30 Vlan100 0
2.2.2.2 0 Full/DROther 00:00:37 Vlan200 0
3.3.3.3 2 Full/Backup 00:00:31 Vlan100 0
4. Restart DR and BDR election:
# Use the shutdown and undo shutdown commands on interfaces to restart DR and BDR election.
(Details not shown.)
# Display neighbor information on Switch A. The output shows that Switch C becomes the BDR.
[SwitchA] display ospfv3 peer
OSPFv3 Process 1 with Router ID 1.1.1.1
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID Pri State Dead-Time Interface Inst ID
2.2.2.2 0 Full/DROther 00:00:36 Vlan200 0
3.3.3.3 2 Full/Backup 00:00:35 Vlan100 0
4.4.4.4 1 Full/DROther 00:00:33 Vlan200 0
# Display neighbor information on Switch D.
[SwitchD] display ospfv3 peer
OSPFv3 Process 1 with Router ID 4.4.4.4
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID Pri State Dead-Time Interface Inst ID
1.1.1.1 100 Full/DR 00:00:30 Vlan100 0
2.2.2.2 0 2-Way/DROther 00:00:37 Vlan200 0
3.3.3.3 2 Full/Backup 00:00:31 Vlan100 0
The output shows that Switch A becomes the DR.
Configuring OSPFv3 route redistribution
Network requirements
As shown in Figure 78:
• Switch A, Switch B, and Switch C are in Area 2.
To Next Page
Loading...
