HP 6125XLG - Adding the Interface MTU into DD Packets; Configuring the Maximum Number of External Lsas in LSDB

72
Ste
p
Command
Remarks
3. Enter area view.
area area-id N/A
4. Configure area authentication
mode.
authentication-mode { md5 | simple }
By default, no
authentication is
configured.
5. Return to OSPF view.
quit N/A
6. Return to system view.
quit N/A
7. Enter interface view.
interface interface-type interface-number N/A
8. Configure interface
authentication mode.
• Configure simple authentication:
ospf authentication-mode simple { cipher
cipher-string | plain plain-string }
• Configure MD5 authentication:
ospf authentication-mode { hmac-md5 |
md5 } key-id { cipher cipher-string | plain
plain-string }
Use either method.
By default, no interface
authentication is
configured.
Adding the interface MTU into DD packets
By default, an OSPF interface adds a value of 0 into the interface MTU field of a DD packet rather than
the actual interface MTU. You can enable an interface to add its MTU into DD packets.
To add the interface MTU into DD packets:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable the interface to add its
MTU into DD packets.
ospf mtu-enable
By default, the interface adds an
MTU value of 0 into DD packets.
Configuring the maximum number of external LSAs in LSDB
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Specify the maximum number
of external LSAs in the LSDB.
lsdb-overflow-limit number
By default, the
maximum number of
external LSAs in the
LSDB is not limited.