HP 6125XLG - Configuring OSPF Network Management; Configuring the LSU Transmit Rate

74
Ste
p
Command
Remarks
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Enable the logging of
neighbor state changes.
log-peer-change
By default, this feature is
enabled.
Configuring OSPF network management
OSPF network management allows you to save system resources by enabling trap generation to report
important events and configuring the maximum number of output traps for a specific time period.
To configure OSPF network management:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Bind OSPF MIB to an
OSPF process.
ospf mib-binding process-id
By default, OSPF MIB is bound to
the process with the smallest
process ID.
3. Enable SNMP traps
for OSPF.
snmp-agent trap enable ospf
[ authentication-failure | bad-packet |
config-error | grhelper-status-change |
grrestarter-status-change | if-state-change
| lsa-maxage | lsa-originate |
lsdb-approaching-overflow |
lsdb-overflow | neighbor-state-change |
nssatranslator-status-change | retransmit |
virt-authentication-failure | virt-bad-packet
| virt-config-error | virt-retransmit |
virtgrhelper-status-change |
virtif-state-change |
virtneighbor-state-change ] *
By default, SNMP traps for OSPF is
enabled.
4. Configure the
number of output
SNMP traps within a
specified time
interval.
snmp trap rate-limit interval trap-interval
count trap-number
By default, OSPF outputs up to 7
SNMP traps within 10 seconds.
Configuring the LSU transmit rate
Sending large numbers of LSU packets affects router performance and consumes too much network
bandwidth. You can configure the router to send LSU packets at a proper interval and limit the maximum
number of LSU packets sent out of an OSPF interface each time.
To configure the LSU transmit rate:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A