HP 6125XLG - Displaying and Maintaining BGP

223
Ste
p
Command
Remarks
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance vpn-instance-name
N/A
3. Enable BFD to detect the link to the
specified BGP peer.
peer ip-address bfd
By default, BFD is
not enabled.
To enable BFD for a BGP peer (IPv6):
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance vpn-instance-name
N/A
3. Enable BFD to detect the link to the
specified IPv6 BGP peer.
peer ipv6-address bfd
By default, BFD is
not enabled.
Displaying and maintaining BGP
Execute display commands in any view and reset commands in user view (IPv4).
Task Command
Display BGP IPv4 unicast peer group
information.
display bgp group ipv4 [ unicast ] [ vpn-instance
vpn-instance-name ] [ group-name ]
Display BGP IPv4 unicast peer or peer
group information.
display bgp peer ipv4 [ unicast ] [ vpn-instance
vpn-instance-name ] [ ip-address { log-info | verbose } |
group-name log-info | verbose ]
Display BGP IPv4 unicast routing
information.
display bgp routing-table ipv4 [ unicast ] [ vpn-instance
vpn-instance-name ] [ network-address [ { mask | mask-length }
[ longest-match ] ] ]
Display BGP IPv4 unicast route
advertisement information.
display bgp routing-table ipv4 [ unicast ] [ vpn-instance
vpn-instance-name ] network-address [ mask | mask-length ]
advertise-info
Display BGP IPv4 unicast routing
information sent to/received from the
specified BGP peer.
display bgp routing-table ipv4 [ unicast ] [ vpn-instance
vpn-instance-name ] peer ip-address { advertised-routes |
received-routes } [ network-address [ mask | mask-length ] |
statistic ]
Display BGP IPv4 unicast routing statistics.
display bgp routing-table ipv4 [ unicast ] [ vpn-instance
vpn-instance-name ] statistic