Display information about the routes to
OSPFv3 ABR and ASBR.
display ospfv3 [ process-id ] abr-asbr
Display brief OSPFv3 process
information.
display ospfv3 [ process-id ] brief
Display GR status of the specified
OSPFv3 process.
display ospfv3 [ process-id ] graceful-restart status
Display OSPFv3 interface information.
display ospfv3 [ process-id ] interface [ interface-type
interface-number | verbose ]
Display OSPFv3 LSDB information.
display ospfv3 [ process-id ] lsdb [ { external | grace | inter-prefix |
inter-router | intra-prefix | link | network | router | unknown
[ type ] } [ link-state-id ] [ originate-router router-id | self-originate ] |
statistics | total ]
Display OSPFv3 neighbor information.
display ospfv3 [ process-id ] [ area area-id ] peer [ [ interface-type
interface-number ] [ verbose ] | peer-router-id | statistics ]
Display OSPFv3 request list
information.
display ospfv3 [ process-id ] [ area area-id ] request-queue
[ interface-type interface-number ] [ neighbor-id ]
Display OSPFv3 retransmission list
information.
display ospfv3 [ process-id ] [ area area-id ] retrans-queue
[ interface-type interface-number ] [ neighbor-id ]
Display OSPFv3 routing information. display ospfv3 [ process-id ] routing [ ipv6-address prefix-length ]
Display OSPFv3 statistics. display ospfv3 [ process-id ] statistics
Display OSPFv3 virtual link
information.
display ospfv3 [ process-id ] vlink
OSPFv3 configuration examples
Configuring OSPFv3 areas
Network requirements
As shown in Figure 76:
• Enable OSPFv3 on all switches.
• Split the AS into three areas.
• Configure Switch B and Switch C as ABRs to forward routing information between areas.
• Configure Area 2 as a stub area to reduce LSAs in the area without affecting route reachability.
To Next Page
Loading...
