HP 6125XLG - Configuring Actions for an Ipv6 Node; Configuring Ipv6 PBR; Displaying and Maintaining Ipv6 PBR

340
NOTE:
If an ACL match criterion is defined, packets are matched against the ACL rules, and the permit or den
y
action and the time range of the specified ACL are ignored. If the specified ACL does not exist, no packe
t
is matched.
Configuring actions for an IPv6 node
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route policy-name [ deny
| permit ] node node-number
N/A
3. Set next hops for
permitted IPv6
packets.
apply next-hop [ vpn-instance
vpn-instance-name ] { ipv6-address [ direct ]
[ track track-entry-number ] }&<1-n>
By default, no next hop is specified.
You can specify multiple next hops for
backup, which are executed in the
order they are configured.
The value of n is 2.
Configuring IPv6 PBR
Configure IPv6 PBR by applying an IPv6 policy to an interface. IPv6 PBR uses the policy to guide the
forwarding of IPv6 packets received on the interface. The specified policy must exist. Otherwise, the IPv6
interface PBR configuration fails.
You can apply only one policy to an interface. Before you apply a new policy, you must first remove the
current policy from the interface.
You can apply the same IPv6 policy to multiple interfaces.
To configure IPv6 interface PBR:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type interface-number N/A
3. Apply an IPv6
policy to the
interface.
ipv6 policy-based-route policy-name
By default, no IPv6 policy is
applied to the interface.
Displaying and maintaining IPv6 PBR
Execute display commands in any view and reset commands in user view.
Task Command
Display IPv6 PBR policy information. display ipv6 policy-based-route [ policy policy-name ]
Display IPv6 PBR configuration. display ipv6 policy-based-route setup