HP 6125XLG - Configuring the Maximum Number of ECMP Routes; Configuring OSPF Preference

65
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure a bandwidth
reference value.
bandwidth-reference value
The default setting is 100
Mbps.
Configuring the maximum number of ECMP routes
Perform this task to implement load sharing over ECMP routes.
To configure the maximum number of ECMP routes:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3. Configure the maximum
number of ECMP routes.
maximum load-balancing maximum
By default, the
maximum number of
ECMP routes is the
same as that configured
in the max-ecmp-num
command. For more
information about the
max-ecmp-num
command, see IP
Routing Command
Reference.
Configuring OSPF preference
A router can run multiple routing protocols, and each protocol is assigned a preference. If multiple routes
are available to the same destination, the one with the highest protocol preference is selected as the best
route.
To configure OSPF preference:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ] *
N/A
3. Configure a
preference for OSPF.
preference [ ase ] [ route-policy
route-policy-name ] value
By default, the preference of OSPF
internal routes is 10 and the preference
of OSPF external routes is 150.