HP 6125XLG - Page 137

126
Ste
p
Command
Remarks
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Specify the minimum
interval for sending LSPs
and the maximum LSP
number that can be sent at a
time.
isis timer lsp time [ count
count ]
By default, the minimum interval is
33 milliseconds, and the maximum
LSP number that can be sent at a
time is 5.
Specifying LSP lengths
IS-IS messages cannot be fragmented at the IP layer because they are directly encapsulated in frames.
IS-IS routers in an area must send LSPs smaller than the smallest interface MTU in the area.
If the IS-IS routers have different interface MTUs, HP recommends configuring the maximum size of
generated LSP packets to be smaller than the smallest interface MTU in the area. Otherwise, the routers
must dynamically adjust the LSP packet size to fit the smallest interface MTU, which takes time and affects
other services.
To specify LSP lengths:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
3. Specify the maximum length
of generated Level-1 LSPs or
Level-2 LSPs.
lsp-length originate size [ level-1 |
level-2 ]
By default, the maximum length
of generated Level-1 LSPs or
Level-2 LSPs is 1497 bytes.
4. Specify the maximum length
of received LSPs.
lsp-length receive size
By default, the maximum length
of received LSPs is 1497 bytes.
Enabling LSP flash flooding
Changed LSPs can trigger SPF recalculation. To advertise the changed LSPs before the router recalculates
routes for faster network convergence, enable LSP flash flooding.
To enable LSP flash flooding:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A
2. Enter IS-IS view.
isis [ process-id ] [ vpn-instance vpn-instance-name ] N/A
3. Enable LSP flash
flooding.
flash-flood [ flood-count flooding-count |
max-timer-interval flooding-interval | [ level-1 |
level-2 ] ] *
By default, LSP flash
flooding is disabled.
Enabling LSP fragment extension
Perform this task to enable IS-IS fragment extension for an IS-IS process. The MTUs of all interfaces
running the IS-IS process must not be less than 512. Otherwise, LSP fragment extension does not take
effect.
To enable LSP fragment extension: