Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Create an EBGP peer group.
group group-name external
By default, no EBGP peer group is
created.
4. Create an IPv6 BGP peer and
specify its AS number.
peer ipv6-address as-number
as-number
By default, no IPv6 BGP peer is
created.
5. Add the peer into the EBGP
peer group.
peer ipv6-address group
group-name [ as-number
as-number ]
By default, no peer exists in the
peer group.
The as-number as-number option,
if used, must specify the same AS
number as the peer ip-address
as-number as-number command.
6. (Optional.) Configure a
description for the peer group.
peer group-name description
description-text
By default, no description is
configured for the peer group.
7. Create and enter BGP IPv6
unicast instance view or
BGP-VPN IPv6 unicast
instance view.
ipv6-family [ unicast ]
By default, the BGP IPv6 unicast
instance view and BGP-VPN IPv6
unicast instance view are not
created.
8. Enable the router to exchange
IPv6 unicast routing
information with peers in the
specified peer group.
peer group-name enable
By default, the router cannot
exchange IPv6 unicast routing
information with the peers.
To configure an EBGP peer group by using Method 3 (IPv4):
Ste
Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Create an EBGP peer group.
group group-name external
By default, no EBGP peer group is
created.
4. Add a peer into the EBGP
peer group.
peer ip-address group group-name
as-number as-number
By default, no peer exists in the
peer group.
5. (Optional.) Configure a
description for the peer group.
peer group-name description
description-text
By default, no description is
configured for the peer group.
To Next Page
Loading...
