HP 6125XLG - Page 207

196
Step Command Remarks
3. Enter BGP IPv4 unicast
instance view or BGP-VPN
IPv4 unicast instance view.
ipv4-family [ unicast ] N/A
4. Configure the default MED
value.
default med med-value The default MED value is 0.
To configure the default MED value (IPv6):
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv6 unicast
instance view or BGP-VPN
IPv6 unicast instance view.
ipv6-family [ unicast ] N/A
4. Configure the default MED
value.
default med med-value The default MED value is 0.
Enabling MED comparison for routes from different ASs
This task enables BGP to compare the MEDs of routes from different ASs.
To enable MED comparison for routes from different ASs (IPv4):
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv4 unicast
instance view or BGP-VPN
IPv4 unicast instance view.
ipv4-family [ unicast ] N/A
4. Enable MED comparison for
routes from different ASs.
compare-different-as-med By default, this feature is disabled.
To enable MED comparison for routes from different ASs (IPv6):
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter BGP view.
bgp as-number N/A