HP 6125XLG - Page 293

282
Figure 73 Network diagram
Device Interface IPv6 address
Device
Interface
IPv6 address
Switch A Vlan-int10 12::1/64
Switch B
Vlan-int12 11::1/64
Vlan-int11 10::102/64 Vlan-int13 13::1/64
Loop1 1::9/128
Loop1
2::9/128
Switch C Vlan-int11 10::100/64
Switch D
Vlan-int10 12::2/64
Vlan-int13 13::2/64 Vlan-int12 11::2/64
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure IPv6 static routes and BFD:
# Configure IPv6 static routes on Switch A and enable BFD control packet mode for the IPv6 static
route that traverses Switch D.
<SwitchA> system-view
[SwitchA] interface loopback 1
[SwitchA-LoopBack1] bfd min-transmit-interval 500
[SwitchA-LoopBack1] bfd min-receive-interval 500
[SwitchA-LoopBack1] bfd detect-multiplier 9
[SwitchA-LoopBack1] quit
[SwitchA] ipv6 route-static 120:: 64 2::9 bfd control-packet bfd-source 1::9
[SwitchA] ipv6 route-static 120:: 64 10::100 preference 65
[SwitchA] quit
# Configure IPv6 static routes on Switch B and enable BFD control packet mode for the static route
that traverses Switch D.
<SwitchB> system-view
[SwitchB] interface loopback 1
[SwitchB-LoopBack1] bfd min-transmit-interval 500
[SwitchB-LoopBack1] bfd min-receive-interval 500
[SwitchB-LoopBack1] bfd detect-multiplier 9
[SwitchB-LoopBack1] quit
[SwitchB] ipv6 route-static 121:: 64 1::9 bfd control-packet bfd-source 2::9
[SwitchB] ipv6 route-static 121:: 64 13::2 preference 65
[SwitchB] quit
# Configure IPv6 static routes on Switch C.
<SwitchC> system-view
[SwitchC] ipv6 route-static 120:: 64 13::2
[SwitchC] ipv6 route-static 121:: 64 10::102
Switch A Switch B
Switch C
BFD
Vlan-int10
Vl
an-
int11
Vlan-int11 Vlan-int13
Vlan-
i
nt13
Vlan-int10
121::/64
120::/64
Switch D
Vlan-int12
Vlan-int12
Loop1
1::9/128
Loop1
2::9/128