Warning
Use of controls or adjustments or performance of procedures other
than those specified for the laser source may result in hazardous
radiation exposure.
Warning
Refer Servicing only to qualified and authorized personnel.
Warning
Do not enable the laser when there is no fiber attached to the optical
output connector.
The optical output connector is at the bottom, on the laser module
front panel.
The laser is enabled by pressing the grey button above the optical
output connector on the front panel. The laser is enabled when the
green LED on the front panel of the laser module is Iit.
Warning
Under no circumstances look into the end of an optical cable attached
to the optical output when the device is operational.
The laser radiation is not visible to the human eye, but it can seriously
damage your eyesight.
Introduction
This manual is arranged into four categories:
• Descriptions of theory of operation. Chapter 1.
• Functional tests and troubleshooting information. Chapters 2, 3,
and 4.
• Component Level Information Package (optional).
P/N
o
f/,
~J - ~
.:><;)0]'
This consists of
o
the circuit diagrams,
o the board layouts, and
o the replaceable parts lists.
-
viii
To Next Page
Loading...
