3
Assembling and Disassembling the Instrument
Except where noted, assembling the instrument is the reverse of the
procedure given for disassembling.
Removing the Instrument Housing
Note
You will need a
TORX
screwdriver to perform this task.
1. Make sure that the power cord is removed.
2. Loosen the 2
TORX
screws (T15x80) on the rear bezel and
remove it.
3. Remove the screw on the bottom of the housing and pull the
instrument out of the housing.
Removing the Front Panel Assembly
1. Remove the instrument housing (see "Removing the Instrument
Housing") .
2. Disconnect the flat-cable connector (J302) from the processor
board.
3. Lift the upper and lower part of the plastic frame at the front of
the instrument and push out the front panel assembly, (The front
panel assembly is clipped into the plastic frame.)
Assembling and Disassembling the Instrument 3-1
To Next Page
Loading...
