HP 8153A - Page 140

The OPERatioii:TRIGger Node
This node gives a summary of the triggering status. Bit 0 returns the status
of the power node. A 1 means that the instrument is triggering, or has been
triggered. Bit 5 of the OPERation node summarizes this node.
The OPERation:TRIGger:POWer Node
This node gives a summary of the triggering, Bit 0 returns the status of the
triggering of the module in channel A. Bit 1 returns the status of the triggering
of the module in channel B. A 1 means that the instrument is triggering, or has
been triggered. Bit 0 of the OPERation:TRIGger node summarizes this node.
The OPERatiomCORRecting Node
This node gives a summary of the correcting status. Bit 0 returns the status of
the ZERO node. A i means that a correction is being made, or has been made.
Bit 7 of the OPERation node summarizes this node.
The OPERation:CORRectmg:ZERO Node
This node gives a summary of the zeroing, that is the removal of electrical
olfsets. Bit 0 returns the status of the zeroing of the module in channel A. Bit
1 returns the status of the zeroing of the module in channel B. A 1 means that
zeroing is taking place, or has taken place. Bit 0 of the OPERation:CORRecting
node summarizes this node.
The OPERation:AVERaging Node
This node gives a summary of the averaging status. Bit 0 returns the status
of the POWer node. A means that readings are being averaged, or have been
averaged. Bit 8 of the OPERation node summarizes this node.
The OPERatioii:AVERagiiig:POWer Node
This node gives a summary of the power averaging, that is the result is an
average of a number of results. Bit 0 returns the status of the averaging of the
module in channel A. Bit 1 returns the status of the averaging of the module In
channel B. A 1 means that averaging is taking place, or has taken place. Bit 0 of
the OPP]Ration:AVERaging node summarizes this node.
7-12 Remote Operation ■ Status Commands