HP 8153A - Page 95

The Module Type
The module type is indicated by the last two numeric digits of the product
number. Not all locations have a module type. That is, the standard setting,
and locations that have not been used to store configuration data do not have a
module type parameter. You must have the correct module type in the selected
channel to make a recall. If you do not, the message MISMATCH will be shown
when you try to make a recall.
The Location
The location where the configuration data is stored is a number between 0 and
9. This number is displayed to the left of the arrow.
You edit the location using the Modify keys. The location used for the recall is
the displayed value.
Location 0 always contains the standard setting. The standard setting is:
Parameter Setting
Sensor
A
CAL
T
REF
Auto Ranging
Units
Display
Module dependant.
O.OOOdB.
200ms (500ms for Head Interface Module).
1000.0/iW.
Enabled.
Watts
lAill Resolution
Source
A
ATT
AUX
Output
Module dependant, lower wavelength for dual wavelength
source.
O.OdB.
CW.
Disabled.
The Channel
This is either the letter A or the letter B. It is displayed to the right of the arrow.
You must have the correct module type in the selected channel to make a recall.
Local Contol • System Mode 4-3