HP 8153A - Page 96

If you do not, the message MISMATCH will be shown when you try to make a
recall.
You edit the channel using the Modify keys. The channel that will be set by the
data is the displayed value.
Example The character field shows the message RECALL ’54 3^ A.
You press
If there is an HP 81564SM in channel A, channel A will be
configured according to the data in location 3.
STORE
The store function stores the instrument configuration in memory. When you
select the store function, the left side character field shows the message STORE.
There are three parameters for this function. The module type for which the
last save to this location was made, the channel for which the information is to
be saved, and the location where the data is to be saved.
Press [Edit] to look at or edit the parameters. All of the parameters are displayed
at the same time in the right side character field. You can select between the
location and the channel using and (^. You cannot edit the module type.
While you are editing parameters, the mode-indicator shows MEMU SYS EDIT.
Figure 4-2. Editing a Parameter in System Mode
Press (EXEC I to make a store with the selected parameters.
4-4 Local Contol - System Mode