I
-
I
-
Using instrument Functions
Connecting and Configuring Printers and Plotters
5.
Press
I&z.%
PC&S
to change the margins and print width:
a.
Top
lfargin
: Sets the top margin (non-printing space) of the printout
in mm. Minimum setting is 0.00 mm; maximum setting is 200.00 mm.
b.
Left
Margin
: Sets the left margin (non-printing space) of the
printout in mm. Minimum setting is 0.00 mm; maximum setting is
200.00 mm.
c. Print Width : Sets print width (printing space) of printout in mm.
Minimum setting is SO mm; maximum is 500 mm. Width is
delined
relative to the printer. It is the dimension at right angle to the travel
of the paper. Landscape mode is rotated one-quarter turn relative to
portrait mode. Thus, in landscape mode, print width actually defines
the height of the printed image.
PC15 “PRINT DVERRUN” Errors and Page Protection
When printing using
PCL5
format, the printed page’s complexity may exceed the printer’s ability to
create the image and keep pace with the engine printing process. If a page is too complex, the page
might print in parts, or only part of the page might print. Some print data loss is likely In such
cases, a “PRINT OVERRUN” message appears in the printer’s display
To sofve this problem, some printers have a feature called “Page Protection” which reserves printer
memory for the page image process, allowing the printer to create the entire page in memory before
physically moving the paper through the printer. This process ensures that the entire page will be
printed.
Enable the page protection feature by consulting your printer manual. Note: some printers require
2 MB of memory, or more, to support this page protection feature.
4-83
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
