I
-
I
-
Entering
Measurement
Parameters
This section describes how to input measurement parameter information into
the network analyzer.
NOTE
When entering parameters, you can use the numeric key pad, as described in each example, or you
can use the
m
a
keys or the front panel knob to enter data.
NOTE
When you are instructed to enter numeric values in this manual, it often can get cluttered and
confusing to depict each key stroke. So in this manual, numbers
Ino
matter how many characters)
are depicted inside one keycap. For example, if you are instructed to enter the number -42.5, it will
be depicted inside one keycap like this:
I--42.5).
To enter this number, the following keys need to
pressed in succession:
Q
@
@
0
0.
I
I
You can follow along with these examples by connecting the filter and cable
that were supplied with your instrument as shown in Figure 2-2.
2-4
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com
To Next Page
Loading...
Need help?
General
