HP 8711C User Manual

E
DOS formatted disks, 4-74
downloading cal kit standards, 6-18
DR.&A’
graphics keyword, 7-21
drift compensation, detectors, 6-15
DTR/DSE ) 9-22
dual channel measurements, 2- 12
dynamic range
change measurement averaging, 5-12
changing system bandwidth, 5- 11
factors, 5- 10
increase receiver input power, 5- 10
increasing, 5- 10
receiver, 10-8
reduce receiver floor, 5- 11
dynamic range , iii
dynamic range specifications, 10-2
Edit ,9-23
E&it limi% ,9-23
edit limit example, 4-30
E&k* Limit Bx@~, 9-23
electrical delay
effect on measurements, 5-19
electrical requirements, 1-4
electrostatic
discharge, 1-8, lo-16
precautions, 1-8, lo-16
eliminate receiver spurious responses, 5- 14
End Fxequency (g-23
End Limit ( 9-23
End Lins t ( 9-24
J?bhanced Resume ,9-24
enhanced response calibration, 6- 12
entering parameters, 2-4
Enter Line % , 9-24
Enter Line 2,9-24
environmental characteristics, lo-16
environmental requirements, 1-4
error
unrecoverable, 9-58
errors
frequency response, 6-4
isolation, 6-4
measurement, 6-3
Index- 10
深圳市盛腾仪器仪表有限公司 Tel:0755-83589391 Fax:0755-83539691 Website: www.Sengt.com

HP 8711C Specifications

General

Brand	HP
Model	8711C
Category	Measuring Instruments
Language	English