HP 8753E - Page 104

‘Fable l-11. HP-IB Only Commands (continued)
Action
Mnemonic s ?
Description
MISCELLANEOUS (continued)
self test
TST? 1
Causes a self test. Returns a zero if the test
passes.
Wait WAIT 1
Makes the analyzer wait for a clean sweep
when used with the OPC command.
OUTPUT
Active OUTPACTI 1
Outputs value of function in active entry area
Cunction in ASCII format.
Wax values OUTF’AMAX’
1
Outputs max values for all limit line segments.
Min values OUTPAMIN’
1
Outputs min values for all limit line segments.
Smoothing
OUTPAPER 1
Outputs the smoothing aperture.
Error OUTPCALC<01,02.. . 2
Outputs the selected error coefficient array
coefficient
12>
from the active channel. Each array is the sam
as a data array. See ‘lhble 1-8, for the contents
of the arrays.
Cal kit OUTPCALK 1
Outputs the active cal kit, a less than 1000 bytr
string in FORM 1.
Active
OUTPCHAN 1
Outputs the active channel number.
channel
Data OUTPDATA 1
Outputs the error corrected data from the activl
channel in real/imaginary pairs. See Figure 1-4
OUTPDATF
Data: point OUTPDATP
1
Fast data transfer command for OUTPDATA.
1
Outputs trace data indexed by point. (see
SELPT[D])
Data: range OUTPDATR 1
Outputs trace data for range of point-s. (see
SELMINPT[ D] , SELMAXPT[D])
Crror OUTPERRO 1
Outputs the oldest error in the error queue. The
error number is followed by the error message
in ASCII format (FORM 4).
’ Refer to the “Limit Line and Data Point Special Functions” section in HPEMSIC
%gramming Emmpk Guide.
HP-IB Progrm
‘ng and Command Reference Guide 1-97