ADPTWAVE
ALC
ALTAB
ANAB<ONIOFF>
ANAI[D]
AR
ASEG
ASSS
ATTPl[D]
ATTPB[D]
AUTO
AUXC<ONIOFF>
AVERFACT[D]
AVERO<ONIOFF>
AVERREST
BACI[D]
BANDPASS
Sets adapter to
WAVEguide.
ALC control.
Places the analyzer in the alternate inputs
measurement mode, where measurements
are made on alternate sweeps. See also
I:HI:IPHB;
.
Enables the analog bus for service use.
Measures and displays the data at the
auxiliary input (ANALOG IN). Requires no
complementary information [D] when used
with ANAB<OFF>. However, when used
with ANAB<ON>: Range: 1 to 31.
Measures and displays
AIR
on the active
ChaMel.
Uses all segments for list frequency sweep.
See also SSEG[D].
Asserts the sequence status bit.
Selects the amount of attenuation at PORT
1 (Option 011 with test set only). Range:
0, 10,
ZO...
7OdLS
Selects the amount of attenuation at PORT
2 (Option 011 with test set only). Range:
0, 10,
ZO...
7OdB
Auto scale the active channel.
Enables and disables the auxiliary
channels 3 and 4. OPC-compatible.
Sets the averaging factor on the active
channel. Range: 0 to 999.
Turns averaging ON and OFF on the active
channel.
Restarts the averaging on the active
channel.
Sets the background intensity of the
display. Range: 0 to 100.
Selects the time domain bandpass mode.
l-104
HP-IB Pro@
amming and Command Reference Guide
To Next Page
Loading...
