These 3 commands control the warning beeper, causing it to sound if the
indicated condition occurs:
BEEPDONE<ONIOFF>
The completion of functions such as save,
done with calibration standard, and data
trace saved.
BEEPFAIL<ONIOFF>
A limit test failure.
BEEPWARN<ONIOFF>
The generation of a warning message.
BLAD<ONjOFF>
BR
Blanks the display.
Measures and displays
B/R
on the active
channel.
These commands set the open capacitance values of an open circuit
while it is being defined as a calibration standard:
Range:
f10k(10-15
F)
Range:
6
1
Ok(1
Omz7
F)
Range: ~10k(10-s6 F)
Range:
3dOk(10-45
F)
CAL1
Accepted for compatibility with the HP
8510, where its function is to begin a
calibration sequence.
These commands set the power meter calibration factor corrections for
the particular sensor used. Sensor B is only valid for the HP
438A
which
has two input channels:
CALFCALF[D]
Sets the calibration factor. Range: 0 to
200%.
CALFFREQ[D]
Selects the frequency for the calibration
factor correction. Range: stimulus range.
CALFSENA
CALFSENB
Edits the sensor A calibration factor table.
Edits the sensor B (HP
438A
only)
calibration factor table.
HP-IB
Frogr
amming
and Command Reference Guide
l-105
To Next Page
Loading...
