FORM5
PC-DOS 32-bit floating-point format with 4
bytes-per-number, 8 bytes-per-data point.
The data is preceded by the same header
as in FORMl. The byte order is reversed
to comply with PC-DOS formats. If you
are using a PC-based controller,
FORM5
is
the most effective format to use.
These commands define the format to use on disk initializations:
FORMATDOS
Selects DOS as the disk format.
FORMATIJF
Selects LIF as the disk format.
FREQOFFS<ONIOFF>
Activates the frequency offset instrument
mode. OPC-compatible.
FRJ30
Frequency blank. Turns OFF frequency
notation.
FRER
FULP
HP-B
free run. Acts the same as
IXIEIT
j
.
Selects full page plotting, as opposed to
plotting in one of the four quadrants.
These 3 commands select a forward calibration class, during a 2-port
calibration sequence. They are OPC-compatible if there is only one
standard in the class:
FWDI
Isolation.
FWDM
Match.
FWDT
Transmission.
These 5 commands control the time domain gate. Range: stimulus
range.
GATECENT[D]
Center time.
GATEO<ONIOFF>
Gate ON/OFF. OPC-compatible.
GATESPAN[D]
Span time.
GATESTAR[D]
Start time.
GATESTOP[D]
Stop time.
HP-IB
Progr
amming
and Command Reference Guide
I-
117
To Next Page
Loading...
