These commands input power meter calibration arrays into the
instrument. Values should be entered as 100 x power meter reading in
dB.
INPUPMCALl
Channel 1.
INPUPMCALB
Channel 2.
These commands input a raw data array using the current format. See
OUTPRAW<I>
for the meaning of the arrays. The instrument stops
sweeping, error corrects the data, then formats and displays the data.
INPURAWl[D]
Array 1.
INPURAWB[D]
Array 2.
INPURAW3[D]
Array 3.
INPURAW4[D]
Array 4.
These commands select the instrument mode. They are all
OPC-compatible:
INSMEXSA
External source, auto. OPC-compatible.
INSMEXSM
External source, manual. OPC-compatible.
INSMNETA
Standard network analyzer.
OPC-compatible.
INSMTUNR
Tuned receiver, OPC-compatible.
INTD
-PI
INTM
Selects the internal disk as the active
storage device.
Sets the display intensity, 50 to 100
percent. Range: 50 to 100.
Selects the internal memory for
save/recall.
ISOD
Done with isolation subsequence in a
2-port calibration. OPC-compatible.
ISOL
Begins the isolation subsequence step in a
2-port calibration.
ISOOP
Selects isolation for one path, two port
calibration.
HP-IB
I’rogr
amming
and Command Reference Guide
1-121
To Next Page
Loading...
