Note
The commands for array input and output require the
user to set the data format for transfers in and out of
the instrument. Refer to
‘Iable
l-5 and the mnemonic
descriptions of FORMl,
FORMB,
FORM3,
FORM4,
and
FORM5.
These commands input an individual error coefficient array. Before
sending an array, issue a
CHL
I
X?::KX;
command, where XXXX specifies
the calibration type of the data. Then input the array or arrays. Lastly
store the data with
ft%‘~Z
’
8
,
7.
The instrument goes into hold, displaying
uncorrected data. Complete the process by triggering a sweep. See
Table
l-8 for the contents of the different arrays.
INPUCALCOl[D]
Array 1.
INPUCALC02[D]
Array 2.
INPUCALC03[D]
Array 3.
INPUCALC04[D]
Array 4.
INPUCALCOB[D]
Array 5.
INPUCALCOG[D]
Array 6.
INPUCALC07[D]
Array 7.
INPUCALCOS[D]
Array 8.
INPUCALCOS[D]
Array 9.
lNPUCALClO[D]
Array 10.
INPUCALCll[D]
Array 11.
INPUCALC12[D]
Array 12.
INPUCALK[D]
Inputs a cal kit read out with
OI_ITCALKj
. After the transfer, the data should be
saved into the user cal kit area with
!sH’y’Ei-l!;Et:::;
.
INF’UDATA[D]
Inputs an error corrected data array, using
the current setting of the
FlXM
command.
INPUFORM[D]
Inputs a formatted data array, using the
current setting of the
FOF:14
command.
INPULEAS[D]
Inputs a learn string read out by
I:II-IT/=‘LEH!~;
.
l-120
HP-IB
Progmumi
ng and Command Reference Guide
To Next Page
Loading...
