These 7 commands branch an executing sequence to a new sequence if
the following condition is satisfied.
IFBIEIIGH
Tests the specified input GPIO bit (see
PHRH
I
t.4
C
D
1). If high, invokes the
sequence which follows.
IFBILQW
Tests the specified input GPIO bit (see
PHFF:HTH~Dl).
If low, invokes the
sequence which follows.
IFBW[D]
Sets the IF’ bandwidth. Values: 10, 30,
100,
300,
1000,
3000,3700,
6000
Hz.
IJ?LCEQZESEQ<I>
If loop counter equals zero, then do the
sequence that follows. Range: 1 to 6.
IFLCNEZESEQ<I>
If loop counter does not equal zero, then
do the sequence that follows. Range: 1 to
6.
IFLTF’AILSEQ<I>
If limit test fails, then do sequence that
follows. Range: 1 to 6.
IFLTPASSSEQ<I>
If limit test passes, then do sequence that
follows. Range: 1 to 6.
IMAG
INCRLOOC
Selects the imaginary display format.
Increments the sequencing loop counter
by 1.
Initializes the internal disk. All previous
information on the disk will be destroyed.
Initializes the external disk. All previous
information on the disk will be destroyed.
Requires pass control when using the
HP-H3
port.
HP-IB Programrm
‘ng and Command Reference Guide
1
-I
19
To Next Page
Loading...
