PMTRTTIT
Reads value from power meter or
peripheral at the power meter’s HP-IB
address into title string.
POIN[D]
Sets the number of points in the sweep.
Values: 3, 11, 21, 26, 51, 101, 201, 401,
801, 1601.
POLA
Selects the polar display format.
These 3 commands select the marker readout format for polar display:
POLMLIN
Linear markers.
POLMLOG
Log markers.
POLMRI
Real/imaginary markers.
PORE<ONIOFF>
Turn port extensions ON and OFF.
These 4 commands set the port extension length for the indicated port
or input. Ports 1 and 2 refer to the test set ports. Range:
fl0
s.
PORT1
[D]
PORT2
[D]
PORTA[D]
PORTBID]
PORTP<CPLDIUNCPLD>
PORTRID]
PORTT[D]
POWE[D]
POWLFREQ[D]
POWLLIST
Port 1.
Port 2.
Input A.
Input B.
Selects either coupled or uncoupled for
the port powers of a given channel.
Same as PORTl. Range:
HO
s.
Same as
PORT2.
Range:
f
10 s.
Sets the output power level. See also
PWRR<PAUTO/PMAN>
. Range: option
depc?m!ent.
Selects the frequency for which a power
loss correction is entered. This must be
followed by a POWLLOSS[D], which sets
the value. Range: stimulus range.
Begins editing a power loss list for a
power meter calibration.
HP-IB
Programmi
ng and Command Reference Guide
l-141
To Next Page
Loading...
