SLOPE[D]
SLOPO<ONIOFF>
SM8<0N(OFF>
Enters the power slope value. Range: -2 to
2
dB1GhT-z
Selects whether the power slope is ON or
OFF.
Selects whether spur avoidance is ON or
OFF. Selecting spur avoidance OFF, along
with selecting sampler and attenuator
offsets OFF (see
RAWOFFS<ON(OFF>),
saves substantial time at recalls and
during frequency changes. Spur avoidance
is always coupled between channels:
select
SM8<0FF>
to turn off spur
avoidance for both channels. See BASIC
programming Example
2E:
‘lake4
-
Error
Correction Processed on an External
Computer.
SMIC
Selects Smith chart display format.
The following commands select the marker readout format on a Smith
chart:
SMIMGB
G + jB (conductance and susceptance).
SMIMLIN
Linear magnitude.
SMIMLOG
Log magnitude.
SMIMRI
Real/imaginary pairs (resistance and
reactance).
SMIMRX
R+jX.
SMOOAPER[D]
SMOOO<ONjOFF>
SOFR
Sets the smoothing aperture as a percent
of the trace. Range: 0.05 to 20%
Selects whether smoothing is ON or OFF.
Displays the firmware revision on the
screen.
SOFT<
I>
Acts as though the indicated
softkey
was
pressed. Range: 1 to 8.
SOUP<ONIOFF>
Selects whether the source power is ON or
OFF.
HP-IB
Programnu
‘ng and Command Reference Guide
1-151
To Next Page
Loading...
