HP 8924C - Page 117

117
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Calibrating Status Register Group
The Calibrating Status Register Group contains information about events
associated with calibrating CDMA measurements. This register group uses 16-bit
registers and includes a Condition Register, Transition Filters, an Event Register,
an Enable Register, and a Summary Message. p.
The Calibrating Register Group SMB must be enabled in the Operation Status
Register Group before any of the following events or conditions can be reported
through the Status Byte Register.
Figure 11 on page 118 shows the structure and STATus commands for the
Calibrating Status Register Group.
Table 5 on page 124 details the Calibrating Status Register Group Condition
Register bit assignments.