122
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Calibration Status Register Group
The Calibration Status Register Group contains information about the Test Set’s
hardware.
The Status Byte Register summary message associated with the Calibration Status
Register Group is bit three. The Calibration Register Group SMB must be enabled
in the Questionable Data/Signal Status Register Group before any of the following
events or conditions can be reported through the Status Byte Register.
Figure 12 on page 123 shows the structure and STATus commands for the
Calibration Status Register Group.
Table 5 on page 124 details the Calibration Status Register Group Condition
Register bit assignments.
To Next Page
Loading...
