HP 8924C - Page 127

127
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Call Processing Status Register Group
The Call Processing Status Register Group contains information about the Test
Set’s analog Call Processing Subsystem. This status group is accessed using the
STATus commands. The Call Processing Status Register Group uses 16-bit
registers and includes a Condition Register, Transition Filters, an Event Register,
an Enable Register, and a Summary Message Bit.
Figure 12 shows the structure and STATus commands for the Call Processing
Status Register Group.
Refer to the
"Status Register Structure Overview" on page 108 for a discussion of
status register operation.
Table 5 details the Call Processing Status Register Group’s Condition Register bit
assignments.