144
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
Table 9 CDMA Status Register Group Bit Assignments
Bit Number
Is Condition
Register
Implemented?
Condition/Event Comment
15
14 Not used.
13 NO MS reported FER received This event register bit will be set to a
logic 1 when the MSUT reports FER.
MS reported FER is influenced by the
MS FER Report Interval fields.
12 NO Pilot Strength message received This event register bit will be set to a
logic 1 when the Test Set receives a
Pilot Strength message from the
MSUT. Each Pilot Strength message
will update the CDMA Mobile Report-
ing table, which displays the Status, PN
Offset, Strength, and Keep bit for
CDMA pilot signals.
11 NO Registered This event register bit will be set to a
logic 1 when the front panel display
annunciator “Registering” goes out,
indicating the mobile station has regis-
tered.
10 NO FER Test Passed
9 NO FER Test Failed
8 NO FER Test reached Max Frames
7 YES Service Option 2
6 YES Hard Handoff
5 YES Softer Handoff
4 YES Alerting The Alerting Condition Register bit will
be set to logic 1 while the MSUT is
ringing. This only occurs during a Ser-
vice Option 1 call from the Test SEt
(MSUT terminated).
To Next Page
Loading...
