145
S:\HP8924C\USRGUIDE\BOOK\chapters\hpibstat.fb
Chapter 4, Status Reporting
Status Reporting
3 YES Connected The “Connected” Condition Register
bit will be set to a logic 1 when a call is
connected. See the Connected (annun-
ciator) field description in the HP
8924C Reference Guide.
2 YES Transmitting The “Transmitting” Condition Register
bit will be set to a logic 1 when the Test
Set is in CDMA mode. See "CDMA
and Analog Modes" on page 23.
1 YES Page Sent The “Page Sent” Condition Register bit
will be set to a logic 1 when the the
CALL key is pressed or the correspond-
ing HP-IB command is sent. This Con-
dition bit will remain 1 until the current
call or call attempt has ended. See the
Page Sent (annunciator) field descrip-
tion in the HP 8924C Reference Guide.
0 YES Access Probe The “Access Probe” Condition Register
bit will be set to a logic 1 when a
mobile station sends an access probe
sequence to the Test Set.. This Condi-
tion bit will remain 1 until the current
call or call attempt has ended. See the
Access Probe (annunciator) field
description in the HP 8924C Reference
Guide.
Table 9 CDMA Status Register Group Bit Assignments (Continued)
Bit Number
Is Condition
Register
Implemented?
Condition/Event Comment
To Next Page
Loading...
