HP 8924C - Page 258

258
S:\HP8924C\USRGUIDE\BOOK\CHAPTERS\ibasic.fb
Chapter 6, IBASIC Controller
Interfacing to the IBASIC Controller using Serial Ports
Setting up the AdvanceLink Software
1. Press the TERMINAL function key.
2. Press CONFIG KEYS.
3. Press GLOBAL CONFIG.
Keyboard: USASCII
Personality: ANSI
Language: ENGLISH
Terminal Mode: Alphanumeric
Remote To: enter your PC’s selected serial port number, often, Serial 1
Printer I/F: None
Memory Size: 32K
Plotter I/F: None
Video Type: select your display type
Forms Path: no entry
Screen Size: select your size — 23 or 24
4. Press DONE to return to the Config screen.
5. Press REMOTE CONFIG (to set up the Serial port you selected above in Remote To).
Baud Rate: 9600
Parity/DataBits: None/8
Enq Ack: NO
Asterisk: OFF
Chk Parity: NO
SR(CH): LO
Recv Pace: Xon/Xoff
CS(CB)Xmit: NO
XmitPace: Xon/Xoff
6. Press DONE to return to the Config screen.