HP A-MSR900 Series - Grounding the Router with a Grounding Strip

14
• Ground the router to a properly-grounded grounding strip.
• Ground the router to a grounding conductor buried in the earth.
Grounding the router with a grounding strip
To connect the grounding cable:
1. Remove the grounding screw from the rear panel of the router chassis.
2. Put the OT terminal of the supplied grounding cable on the grounding screw, as shown in Figure
16.
3. Use a screwdriver to fasten the grounding screw, with the grounding cable OT terminal attached,
to the grounding screw hole.
4. Attach the other end of the grounding cable to the grounding strip, as shown in Figure 17.
Figure 16 Connecting the grounding cable to the router
(1) Groundin
g
screw (2) OT terminal
(3) Groundin
g
hole (4) Groundin
g
cable
Figure 17 Connecting the grounding cable to a grounding strip
(1) Hex nut (2) Grounding cable
(3) Naked metal part (4) Groundin
g
post
(5) Groundin
g
strip