HP A5500 HI Series User Manual

38
3. Use Telnet, web, or SNMP to access the IRF fabric from the network management station. (See HP
A5500 HI Switch Series Fundamentals Configuration Guide.)
4. Check that you can manage all member switches as if they were one node.
5. Display the running status of the IRF fabric by using the commands in Table 7.
Table 7 Displaying and maintaining IRF configuration and running status
To do… Use the command…
Display information about the IRF fabric display irf
Display all members’ configurations that take
effect after switch reboots
display irf configuration
Display topology information about the IRF
fabric
display irf topology
NOTE:
To avoid IP address collision and network problems, configure at least one multi-active detection (MAD)
mechanism to detect the presence of multiple identical IRF fabrics and handle collisions. For more
information about MAD detection, see
HP A5500 HI Switch Series IRF Configuration Guide .

HP A5500 HI Series Specifications

General

Switching Capacity	336 Gbps
Forwarding Rate	252 Mpps
QoS	Yes
SFP+ Ports	4
Layer Support	Layer 2/3
Stacking	Yes
Management	CLI, Web, SNMP
MAC Address Table Size	32, 000
Routing Protocol	OSPF, RIP, BGP, IS-IS
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)
Ports	48
10/100/1000Base-T Ports	48
Jumbo Frames	9216 bytes
Dimensions	440 x 430 x 44 mm