%Apr 26 16:46:32:169 2000 HP
DRVMSG/1/InSufficientPwr:
No sufficient power, failed to power on slot 3.
If the system power is normal, you can run the display device command. The FIP in the wait
state is abnormal. The following information displays that the FIP in Slot 3 is faulty:
<HP>display device
Slot No. Board type Status Primary
SubSlots
---------------------------------------------------------------------
0 N/A Absent N/A N/A
1 N/A Absent N/A
N/A
2 N/A Absent N/A
N/A
3 FIP-200 Wait N/A 2
4 RPE-X1 Normal Slave 0
5 RPE-X1 Normal Master 0
6 N/A Absent N/A
N/A
7 N/A Absent N/A N/A
8 FIP-200 Startup N/A
2
9 FIP-200 Startup N/A 2
If the cause cannot be located in the steps above and the problem persists, contact your local
sales agent.
Symptom 2
Symptom
Twenty minutes after the router is powered on or the FIP is inserted with power supply on, the
RUN LED still flashes at 8 Hz, which indicates that the FIP application failed to start or the FIP is
faulty. In this case, the FIP is in the startup state. You can run the display device command.
The following information indicates that FIPs in Slot 8 and Slot 9 are faulty:
<HP>display
device
Slot No. Board type Status Primary
SubSlots
---------------------------------------------------------------------
0 N/A Absent N/A
N/A
1 N/A Absent N/A
N/A
2 N/A Absent N/A
N/A
To Next Page
Loading...
Need help?
General
