HP A6616 User Manual

Installation Tools, Meters and Devices
Installation accessories supplied with the router
 Power cables
 Console cable
 PGND cable
 Mounting brackets
 Cable management bracket
 Blank panel
 ESD-preventive wrist strap
User supplied tools
 Phillips screwdrivers: P1-100 mm, P2-150 mm, and P3-250 mm
 Flat-blade screwdriver: P4-75 mm
 Screws with various specifications
 Various meters and devices, such as hub, configuration terminal, optional modules,
or multimeter.
 Optional cables
Reference
When installing or maintaining the router, you can refer to the following documents shipped
with the router:
 HP A6616 Router Installation Manual
 HP SR6600 Routers Electronic Documentation
Or, you can obtain the latest documents from the documentation center on the website at
http://www.HP.com.
Checklist Before Installation
Table 3-4 Checklist before installation
Item Requirements
Installation
site
Ventilation
 There is a minimum clearance of 10 cm (3.9 in.) around the inlet
vents and exhaust vents for heat dissipation of the router chassis.
 A ventilation system is available at the installation site.
Temperature 0°C to 45°C (32°F to 113°F)
Relative humidity 10% to 95% (noncondensing)
Cleanness Dust concentration ≤ 3 × 10
4
particles/m
3
ESD prevention
 The equipment and the floor are well grounded.
 The equipment room is dust-proof.
 The humidity and temperature are at a proper level, respectively.
 Wear an ESD-preventive wrist strap and uniform when touching a
circuit board.
 Place the removed memory module, CF card, or HIM/MIM on an
antistatic workbench, with the face upward, or put it into an
antistatic bag.
 Touch only the edges, instead of electronic components when
observing or moving a removed memory module, CF card, or
HIM/MIM.

HP A6616 Specifications

General

Brand	HP
Model	A6616
Category	Network Router
Language	English