HP C2488A User Manual

Operating Specifications
Table 1·2. HP C2486A/88A/90A Operating Specifications
Note: The HP C2486A/88A/90A disk drives must be operated within the Disk Drive Environmental
Requirements specified in Table 1-4 in order for them to function properly.
Interface
............................................................. Industry Standard SCSI-2
Controller:
Overhead
time ........................................................... < 500 microseconds
Buffer size
......................................................................... 256 kbytes
Buffer type
...................................................................... Dual-ported
Sector size
........................................................ 180 - 744 Data Field Bytes
Interleave
................................................................................. 1: 1
Logical block size
....................................................... 512, 1024,2048, 4096
Seek Times
(includes settling time)
Track to Track Seek .......................................................... 2.5 milliseconds
Head Switch Time
............................................................ < 1 millisecond
A verage Random
Seek
Reads .................................................................... 8.75 milliseconds
Writes
..................................................................... 9.5 milliseconds
Maximum Seek
............................................................... 18 milliseconds
Notes:
Seek time is defined as the titne from when the actuator begins to move until the head has
settled over the target track. It does not include any controller overhead time or any initiator
overhead time.
The values above are derived from a representative sample of disk drives
measured under normal temperature and voltage conditions.
Track
to track seek time is the mean value of all seek times measured when performing all
possible single track seeks.
A verage random seek time is the time to
do all possible seeks divided by the number of seeks
possible.
Maximum seek time
is the time it takes to seek 2531 physical cylinders.
Spin-up Time
From
Power-On to Ready for Access
Typical:
........................................................................ 14 seconds
From
Power-On to SCSI Bus Selection
Typical:
......................................................................... 3 seconds
Maximum:
....................................................................... 5 seconds
Disk Rotating
Speed ................... , ....................................... 6400 rpm ±0.5%
Rotational Latency (Average time) ..................................... 4.69 milliseconds ±O.5%
1·6 Product Specifications
DRAFT
1/18/93 09:58

HP C2488A Specifications

General

Brand	HP
Model	C2488A
Category	Storage
Language	English