HP C2488A - Page 61

Table A·1. Supported SCSI·2 Commands (continued)
Command Opcode Use Use Description
(hex) Before When
Spinup
Wpl
Enabled
Write
No No
Requests Target to write the data transferred by the Intitiator to
(6-byte) OA
the media. Both 6-byte and lO-byte (extended) formats are
(lO-byte)
2A
supported.
Write
2E No No
The Target perfonns a write followed by an ECC verify pass or a
And Verify byte compare. Relative addressing not supported. (REL=O).
Write Buffer 3B No No
May be used to test Target's data buffer or download code. To
avoid possible data corruption, it is recommended that a
RESERVE command be executed prior to the WRITE BUFFER
command.
Write Long 3F No No Allows Initiator to write one complete physical sector, including
header, data, and ECC fields.
Write Same
41
No
No Requests the Target to write the supplied block of data to the
media a specified number of times.
Notes:
1. WP = Write Protect
2. Mode Select and Mode Sense commands that do not involve saved pages may be used before spinup.
DRAFT
SCSI Command Descriptions A·5
1/18/93 09:58