To Next Page

To Previous Page

2–2 Technical Reference Guide

System Configuration

3. Configure the terminal emulation software with these settings:

❏ Baud rate: 9600

❏ Bits: 8

❏ Parity: None

❏ Stop Bits: 1 (one)

❏ Flow Control: XON/XOFF

4. Using the terminal emulation software, connect to the workstation with a direct connection.

5. Turn on the workstation. The system display is redirected to the serial console device.

Paths

All devices in the HP workstation c8000 are represented by paths in the BCH. To identify the

correct slot or disk drive, use the following tables.

Accessory Card Slots

IDE Drives

Slot Path

1 PCI (33 MHz, 32 bit, half-length) 0/3/5/0

2 PCI (33 MHz, 32 bit, half-length) 0/3/4/0

3 AGP 8X 32 bit 0/4/0/0

4 PCI (33 MHz, 64 bit) 0/3/6/0

5 PCI-X (66 MHz, 64 bit) 0/2/2/0

6 PCI-X (66 MHz, 64 bit) 0/2/3/0

7 PCI-X (133 MHz, 64 bit) 0/0/1/0

Drive Path Hardware Connection

IDE hard drive 1 (or optical drive 3) 0/3/2/0.0.0 IDE 0, master

IDE hard drive 2 0/3/2/0.0.1 IDE 0, slave

IDE optical drive 1 0/3/2/0.1.0 IDE 1, master

IDE optical drive 2 0/3/2/0.1.1 IDE 1, slave

HP c8000 User Manual

Other manuals for HP c8000