1. Remove the two bottom rubber feet from the computer (1).
2. Remove the four Phillips M2.0 × 7.0 screws (2) from under the feet.
3. Remove the two screw covers (3) and two Phillips M2.0 × 3.5 screws (4) from the bottom edge of the
bottom cover.
4. Use a nonmarking, nonconductive tool (1) to release the bottom cover from the computer (2).
5. Remove the bottom cover from the computer (3).
To replace the bottom cover, reverse the removal procedures.
22 Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
