2 Removal and replacement procedures
Required tools
The following items are required for some procedures:
• T-8 Torx screwdriver
• T-10 Torx screwdriver
• T-15 Torx screwdriver
• Phillips screwdriver
Required items
Items required for installation include the following, some of which ship with the disk enclosure:
• Rack mounting kit
• Disk enclosure
• Disk drives and drive blanks
• SAS controller or controller enclosure
• SAS cables
• MiniSAS HD cables
NOTE: The included MiniSAS HD cables can be used with the 12Gb JBOD. In order to
connect the 12Gb JBOD to either a 6Gb Smart Array or to 6Gb HBAs, customers must
purchase the MiniSAS HD to MiniSAS cable.
• Power cables
• Access to a workstation on the server
• Access to the Internet
Safety precautions
Retain and follow all product safety and operating instructions. Always refer to the documentation
(printed or electronic) supplied with your product. If there is a conflict between this document and
the product documentation, the product documentation takes precedence. Observe all warnings
on the product and in the operating instructions to reduce the risk of bodily injury, electric shock,
fire, and damage to the equipment.
General precautions
CAUTION: The installation and maintenance of products must be carried out by qualified
personnel.
If the product sustains damage requiring service, disconnect the product from the AC electrical
outlet and refer servicing to an Hewlett Packard Enterprise authorized service provider. Examples
of damage requiring service include:
• The power cord, extension cord, or plug has been damaged.
• Liquid has been spilled on the product or an object has fallen into the product.
• The product has been exposed to rain or water.
6 Removal and replacement procedures
To Next Page
Loading...
Need help?
General
