EasyManuals Logo

HP dc5100 - Microtower PC Service & Reference Guide

HP dc5100 - Microtower PC
230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #133 background imageLoading...
Page #133 background image
Service Reference Guide, dc5100 376220-001 7–21
Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
7.9 Drives
A Torx T-15 screwdriver is needed to remove and install the guide screws on a drive.
Ä
CAUTION: Make sure personal files on the hard drive are backed up to an external storage device
before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard
drive, you will need to run the Restore Plus! CD to load the Compaq factory-installed files.
7.9.1 Drive Positions
To verify the type and size of the storage device installed in the computer, run Computer Setup.
Drive Positions
Item Description Item Description
1 3.5-inch, internal, standard hard
drive bay
3 3.5-inch drive bay (1.44-MB
diskette drive shown)*
2 5.25-inch drive bay for optional
drives
*A 3.5-inch diskette drive, hard drive, or Zip drive may be installed in this bay but the correct
bezel must be installed to ensure proper air flow.

Table of Contents

Other manuals for HP dc5100 - Microtower PC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP dc5100 - Microtower PC and is the answer not in the manual?

HP dc5100 - Microtower PC Specifications

General IconGeneral
ProcessorIntel Pentium 4 or Intel Celeron D
MemoryUp to 4 GB DDR2 SDRAM
NetworkIntegrated Broadcom NetXtreme Gigabit Ethernet
Operating SystemWindows XP Professional
Optical DriveDVD-ROM, CD-RW, or DVD+/-RW
GraphicsIntel Graphics Media Accelerator 900
AudioIntegrated audio
Expansion Slots1 PCI Express x16, 3 PCI
Ports1 Serial, 1 Parallel
WeightApprox. 22 lbs (10 kg)
Processor SpeedUp to 3.8 GHz
Storage40 GB to 250 GB HDD

Related product manuals