D–12 376220-001 Service Reference Guide, dc5100
Blank screen and the
power LED flashes Red five
times, once every second,
followed by a two second
pause, and the computer
beeps five times. Beeps
continue for five iterations
after which the LED flashes
will continue until the
problem is resolved.
Pre-video memory error. 1. Reseat DIMMs. Power on the
system.
2. Replace DIMMs one at a time to
isolate the faulty module.
3. Replace third-party memory
with HP memory.
4. Replace the system board.
Power LED flashes Red six
times, once every second,
followed by a two second
pause, and the computer
beeps six times. Beeps
continue for five iterations
after which the LED flashes
will continue until the
problem is resolved.
Pre-video graphics
error.
For systems with a graphics card:
1. Reseat the graphics card.
2. Replace the graphics card.
3. Replace the system board.
For systems with integrated
graphics, replace the system board.
Blank screen and the
power LED flashes Red
eight times, once every
second, followed by a two
second pause, and the
computer beeps eight
times. Beeps continue for
five iterations after which
the LED flashes will
continue until the problem
is resolved.
Invalid ROM based on
checksum.
1. Reflash the ROM using a
ROMPaq diskette.
2. Replace the system board.
Monitor does not function
properly when used with
energy saver features.
Monitor without energy
saver capabilities is
being used with energy
saver features enabled.
Disable monitor energy saver
feature.
Dim characters. The brightness and
contrast controls are not
set properly.
Adjust the monitor brightness and
contrast controls.
Cables are not properly
connected.
Check that the graphics cable is
securely connected to the graphics
card and the monitor.
Blurry video or requested
resolution cannot be set.
If the graphics controller
was upgraded, the
correct video drivers
may not be loaded.
Install the video drivers included in
the upgrade kit.
Problem Cause Solution
To Next Page
Loading...
Need help?
General
