6Ć47 Removal and ReplacementC4699Ć90000
Reinstalling the Overdrive
Enclosure
The order in which you replace the screws on
the overdrive enclosure is important.
Take care not to damage the mediaĆsensor
flags. The overdrive enclosure should not
touch them.
Replace the two indicated screws. (
dogĆpoint screws.)
Torx-15
Torx-15
Insert the two indicated screws, but do
not tighten them. ( dogĆpoint
screws.)
Torx-15
Torx-15
Replace the indicated screw and tighten
it, thus aligning the overdrive enclosure
with the left sideĆplate.
Torx-15
Tighten the screws you inserted in step 2.
To Next Page
Loading...
