6Ć34 Removal and Replacement
C4699Ć90000
Removing the Trailing Cable
Remove the right endĆcover page 6Ć10.
Disconnect the trailing cable from the
connector marked P1 on the main PCA,
and from the guides on the right bracket.
Move the carriage out of the service
station.
Release the two indicated clips on the top
of the cartridge carriage by pulling them
slightly outwards.
For DesignJet 230 only, it is also necessary to
release two clips at the bottom of the cartridge
carriage.
To Next Page
Loading...
