330
350C
5Ć7 Functional OverviewC4699Ć90000
Detecting the Lines and Media Edges
The line sensor on the cartridge carriage is used to:
D Detect the left and right media edges.
D Detect and measure lines drawn on media when performing accuracy calibration.
D Scan the setup and alignment sheets.
D Find the platen roller reference mark.
Providing Ink
The DesignJet 250C uses the same four print cartridges as does the DesignJet 650C. The
DesignJet 350C uses the same three color print cartridges as does the DesignJet 750C and
755CM plotters and the same black cartridge as the DesignJet 650C. The DesignJet 230 and
330 plotters use only the black cartridge which is used in the DesignJet 650C.
The distance between the carriage and the writing surface can determine image sharpness. As the
distance increases, the drop shape and directionality degrade and are more difficult to predict. You
can change the distance using the adjusting screw on the carriage. (Details ' chapter 7.)
Bail-Lift
Engaging Tab
Integrated
Line Sensor
Adjusting Screw
Back Slider
Beam
Cross–section
Carriage (Side View)
To Next Page
Loading...
